[. . . ] If the code you have found does not work at all or not properly, try another code by selecting the next code for the brand using the or button, then test the code as described above under 4. When your device reacts, press a few buttons to determine, whether you have found a suitable code. If the code you have found does not work at all or not properly, press EXIT and DEV SEARCH appears again. Please note: - You can reverse the search direction with the or button if you have reacted too slowly to a response from the device. [. . . ] Your remote control finds the correct control settings almost automatically in a few seconds: 1. For example, a program number appears in the display of your satellite receiver. If DEV SEARCH does not appear you can set the function with the or button. Then point the remote control at the device to be controlled while the remote control emits a different ON/OFF signal every 2 seconds. The standard code may provide most of functions needed, but you may miss some key functions. Or you didn´t find any functioning preprogrammed code for a device. Press SET for more than 3 seconds and release it, when CODE SETUP is displayed. Then SELECT KEY is displayed and the next key can be programmed according to step 5 and 6. ­If the programming fails, FAILED is displayed, then repeat reprogramming from step 5. You can stop learning procedure by pressing any device key (TV, DVB etc. Control Any Device On AUX You can use the AUX device key to control any device. If you want to control a 2nd VCR by AUX key, please proceed as follows, see Fig. VCR, OK and enter code number of required to be by AUX controlled device, e. Backlight To save battery capacity you can switch off the LCD illumination. To do so, proceed as follows: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. Adjusting the contrast You can adjust the contrast to improve readability: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. Default settings You can reset your remote control to its factory default setting, e. - This function is recommended only in the event of your remote control malfunctioning seriously. 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press a device button (TV, DVD, etc. [. . . ] As the symbols on the UR 820 LCD could differ from those on the original remote controls you may have to try out all the buttons in order to find the functions. scanning of Programs You can scan the TV or DVB (SAT , CBL , DTT etc. ) programs by: 1 Pressing TV or DVB key, 2 Press and hold the SCAN key for about 4 seconds. Use Macros: Control Home Cinema Set Ups With One Touch Only When you have programmed key code sequences, read above, then you can start output by pressing MACRO and then 1, 2 or 3 simultanously. [. . . ]